Making wooden bench in six easy steps

Even if we could actually harder than it really is, you can bank it in 6 easy steps. After gathering the materials and tools Bank, we can do in a very short time to do. You can get a nice and safe simple wooden bench, one of this piece is both functional and beautiful and something you are sure to get compliments and a big talk. After all, what better than to say: Yes, I did that! "

Bench is easierWith these six steps.

First, before we start measuring the seat frame to our desired size, cut them, and then tack-nail them together. Bench to include drawing a curve on the sides and cut them lengthwise with a saw before them together. This forms the shape of the seat. We can also shape how we see fit.

Then cut the seat slats and sand tables and mark the face. Screw the seat frame tightly together. Glue and nail the slats ofFramework, starting from behind. Aid ¾ inch vertical spacer. A good bank to make design offers easy blade overhang on the front.

According Secondly, we arrive at the junction of banking. glue and screws to secure the legs in front of our seat frame from the first pre-drilling countersink holes for screws and application inside Do the same with the hind legs.

Third Third, it is grinding. Bench making about security, so we chamfering sharp edges and sand the seat and legs roundall surfaces. This avoids board from grain or fibers protrude and hurt you. Sanding also creates jobs look better.

Fourth Fourth, we take care to return in the bank. Get help measure the top and add a space of 8.5 inches from driving to the back of the rear legs. This should be an area of 8.1-inch bottom rail between the rear leg and rail.

Then put the pins router or languages and vertical fins on the back end.It should be a corresponding slot on the top bar. The language should easily fit into the groove. Glue the slats and nail them.

Fifth Fifthly, the bank with guns need to put wood studs 3 1 / 2 by 4.3 inches by 3'4 front legs to support. Make a hole of 16.3 inches with a drill at the center of the tunnel and have installed the struts around the corner.

The arm goes from the back of the hind legs of a couple of inches you measure the front leg. A rear armrest shouldreceive the support of the rear leg. Drill a hole and stick the tip of the cleat piercing front lower arm and then unscrew.

Then sixth sixth is final sanding. Bench should do to adjust to the end with all surfaces, ends and corners prior to painting. We have our beautiful, simple, sturdy bench.